I installed a rear cargo deck on our quicksilver 10.0. It's a Curt 18100 Aluminum Cargo deck I ordered on amazon. I assembled it without the 2" folding receiver tubes so it would sit flat on my bumper. Without the receiver tube, I used a couple pieces of 1/2" conduit as spacers when attaching the support brackets. To attach it, I removed the 2 support-pole brackets from the camper. I drilled matching holes in the rack and then reinstalled the brackets through the side of the rack, bolting it firmly to the frame. I also bolted the rack to the bumper. I temporarily removed the taillights and drilled the bolt hole right above the electrical access so I could install the washer and nut on the bolt. I installed a couple of fork mount blocks on the base of the cargo rack so I can transport bikes. We've only transported normal bikes, not e-bikes but everything seems very sturdy. We've put on about 2000km with bikes on the rack. Everything is still tight and nothing has bent.